If your machine has low acceleration or you see darker burns at the sides of your fills, you may need to increase the amount of overscanning. When enabled, adds extra moves to the beginning and end of each line to give the laser time to speed up before firing, and slow down afterward. When enabled, runs a second engraving pass at 90 degrees from the first. When disabled, the laser will engrave traveling one way, then return to the start of the next line, not engraving the return pass. When enabled, the laser will engrave in a side-to-side sweeping motion, engraving in one direction and again for the return direction. 'Fill mode' was called 'Scan' in older versions of LightBurn, because it scans back and forth across the shape, but was renamed to 'Fill' to make it easier to understand for new users. Numeric Edits - size, position, orientationįill mode has different settings, shown below:
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |